[HamWAN PSDR] Yakima County Mesh

[Bart Kus]

Hi Chad,

Can you share your list of nodes (GPS locations)?  That would help with 
interconnect planning.  Ours is published on our website.

--Bart


On 4/6/2017 1:42 PM, Tom Hayward wrote:
> Hi Chad,
>
> There are HamWAN users in Spokane and on the west side. We are very
> eager to bridge that gap.
>
> Jim K7LL is in Pullman and looking to link toward Spokane and Walla Walla.
>
> To directly connect your network with HamWAN, you will need to use
> public address space. You can get these addresses from AMPR if you
> need (http://www.ampr.org/). What address space are you using
> currently? HamWAN filters private address space from its routing
> table, because it's assumed to be an accidental leak from someone's
> home LAN. However, you could NAT or tunnel if you had to pass traffic
> from a private network over HamWAN.
>
> Tom KD7LXL
>
> On Thu, Apr 6, 2017 at 12:49 PM, Chad Smith <chad at verishare.net> wrote:
>> Greetings. Here in Yakima we use the AREDN.ORG firmware with Ubiquiti radios
>> on 2397Mhz. I realize the HamWan is a different beast, however we are
>> looking at expanding our network. Currently we are just in Yakima, Selah and
>> getting into the lower valley toward tri-cities. There is also a tunnel to
>> the Walla Walla mesh network. I would like to open a dialog with you folks
>> about possible future expansion state wide as well and advise on updating
>> out network.
>>
>>
>> Regards,
>>
>> Chad Smith
>> KA7HAK
>>
>> Node Map
>> https://tinyurl.com/mtrmolu
>>
>> Facebook Group
>> https://www.facebook.com/groups/696152693769185/
>>
>>
>>
>>
>> _______________________________________________
>> PSDR mailing list
>> PSDR at hamwan.org
>> http://mail.hamwan.net/mailman/listinfo/psdr
>>
> _______________________________________________
> PSDR mailing list
> PSDR at hamwan.org
> http://mail.hamwan.net/mailman/listinfo/psdr