[HamWAN PSDR] setting a Dynadish 5 as a dhcp client on wlan1 fails

[Doug Kingston]

Steve - please send me a direct contact email.  You can reach me at
kd7dk at arrl.net or my address on QRZ.

-Doug-

On Wed, Feb 13, 2019 at 12:08 PM Doug Kingston <dpk at randomnotes.org> wrote:

> I can take care of these updates.  I'll work with Steve.
>
> -Doug-
>
> On Wed, Feb 13, 2019 at 12:00 PM Steve - WA7PTM <psdr-list at aberle.net>
> wrote:
>
>> Is anyone maintaining the
>>
>> https://www.hamwan.org/Standards/Network%20Engineering/Client%20Node%20Configuration.html
>> web page?
>>
>> The reasons I ask are:
>>
>> • Step 1 will not work as listed as the command is wrong (should be
>> "/system package update install" in RouterOS v6.43.12) and if some
>> preliminary steps are not taken (moving the default network to one
>> connected to the Internet with a "/ip address add address=a.b.c.d/xx
>> interface=ether1" command and establishing a default gateway with a "/ip
>> route add gateway a.b.c.gw" command), then the update will fail.
>>
>> • Step 21 on a Dynadish5 results in a "failure: incompatible band and
>> channel-width" message unless "channel-width=5mhz" is added to the
>> command.
>>
>> • Step 22 on a Dynadish5 results in a "failure: can not run on slave
>> interface" message.
>>
>> This last one has me stumped, and I have been unable to determine a
>> workaround.  Has anyone else encountered and solved this problem?
>>
>> Thanks,
>> Steve
>>
>>
>> _______________________________________________
>> PSDR mailing list
>> PSDR at hamwan.org
>> http://mail.hamwan.net/mailman/listinfo/psdr
>>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.hamwan.net/pipermail/psdr/attachments/20190213/1c3b62ca/attachment.html>