[HamWAN PSDR] setting a Dynadish 5 as a dhcp client on wlan1 fails

[Doug Kingston]

I can take care of these updates.  I'll work with Steve.

-Doug-

On Wed, Feb 13, 2019 at 12:00 PM Steve - WA7PTM <psdr-list at aberle.net>
wrote:

> Is anyone maintaining the
>
> https://www.hamwan.org/Standards/Network%20Engineering/Client%20Node%20Configuration.html
> web page?
>
> The reasons I ask are:
>
> • Step 1 will not work as listed as the command is wrong (should be
> "/system package update install" in RouterOS v6.43.12) and if some
> preliminary steps are not taken (moving the default network to one
> connected to the Internet with a "/ip address add address=a.b.c.d/xx
> interface=ether1" command and establishing a default gateway with a "/ip
> route add gateway a.b.c.gw" command), then the update will fail.
>
> • Step 21 on a Dynadish5 results in a "failure: incompatible band and
> channel-width" message unless "channel-width=5mhz" is added to the command.
>
> • Step 22 on a Dynadish5 results in a "failure: can not run on slave
> interface" message.
>
> This last one has me stumped, and I have been unable to determine a
> workaround.  Has anyone else encountered and solved this problem?
>
> Thanks,
> Steve
>
>
> _______________________________________________
> PSDR mailing list
> PSDR at hamwan.org
> http://mail.hamwan.net/mailman/listinfo/psdr
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.hamwan.net/pipermail/psdr/attachments/20190213/7ab8a802/attachment.html>