[HamWAN PSDR] Larch Mnt [N7DOD]

[Tom Hayward]

I didn't realize those modems didn't come with a license that allows AP
mode. That will preclude the test I suggested.

I think you're QRT-5 should be able to do AP mode. You could set it for AP
mode and see if the other modem can connect to it.

Tom

On Mon, Aug 27, 2018, 19:28 Scott J. Burrows <sburrows97211 at comcast.net>
wrote:

> tom, I reset the modem and tried the command again.
> the results were different ...
>
> ---
> New Outlook Express and Windows Live Mail replacement - get it here:
> https://www.oeclassic.com/
>
>
> [admin at MikroTik] /interface wireless> set wlan1 mode=ap-bridge
> channel-width=5mhz
> failure: license does not allow AP mode
> [admin at MikroTik] /interface wireless> /
> [admin at MikroTik] > sys lic pr
>   software-id: 71BK-YKAU
>        nlevel: 3
>      features:
> [admin at MikroTik] >
>
> scott, n7dod
>
>
> *----- Original Message -----*
> *From:* Tom Hayward <tom at tomh.us>
> *Reply-To:* Puget Sound Data Ring <psdr at hamwan.org>
> *To:* Puget Sound Data Ring <psdr at hamwan.org>
> *Sent:* 8/27/2018 4:24:09 PM
> *Subject:* Re: [HamWAN PSDR] Larch Mnt [N7DOD]
> ------------------------------
> On Mon, Aug 27, 2018 at 11:39 AM Scott J. Burrows <
> sburrows97211 at comcast.net> wrote:
>
>> Yes, all testing was done individually.  I was told that Mikrotik
>> 802.11ac modems do not support 5 and 10 MHz channels.  This maybe the
>> problem with Node-1.  I was given a couple of commands from Tom Hayward to
>> try and see if the modem supported HamWAN.  This test failed, and thus most
>> likely will not work for HamWAN usage.
>>
>
> I'm curious what the failure looked like. Did it report an error about
> unsupported channel-widths?
>
> Tom
>
> _______________________________________________
> PSDR mailing list
> PSDR at hamwan.org
> http://mail.hamwan.net/mailman/listinfo/psdr
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://mail.hamwan.net/pipermail/psdr/attachments/20180827/a7f481ea/attachment.html>